Cold Pour Crack Filler

TA-300 S/M cold pour crackfiller is a blend of asphalt emulsion, suitable fillers, and is “Super Modified” with a blend of “three select polymers” for greater flexibility and adhesion in asphalt or concrete surfaces. TA-300 is available at many Graniterock branch locations.

PHYSICAL PROPERTIES

• TA-300 S/M meets or exceeds the following
• Specifications: ASTM D 2939
• Residue at 300–400°F: 60–70%
• Solubility of Residue in C2HC13: 85–95
• Firm Set: 90 Mins.
• Viscosity @ 77°F Brookfield, Spindle #3 @ 20 rpm: 300–700 cps
• Water resistance: PASS
• Flexibility: PASS
• Ash content of insoluble residue: 70% min.
• Surface Preparation

Cracks must be dry and clean of all loose foreign matter. Use of compressed air or water jet is recommended. Apply a suitable weed killer prior to crackfilling with TA-300 S/M.

APPLICATION
Mix TA-300 S/M thoroughly before using. Use as received from the container. For best results, apply TM-300 S/M with a pour pot or suitable crack sealing applicator. Fill cracks to the surface, scrape excess material using a “V” shaped rubber squeegee to minimize waste and maximize adhesion. Prior to TA-300 S/M curing, sprinkle silica sand (lightly) to promote adhesion of Poly-Kote TA-1000.

COVERAGE
Indefinite. For estimated purposes; up to 315 linear feet of ½″ × ½″ crack per 5 gallon pail. For bottomless cracks, fill with sand to ¾″ – 1″ of the pavement surface. (see chart on back)

CURE TIME
Depends on air temperature, humidity and width and depth of crack. For early pedestrian or vehicle traffic, cover TA-300 S/M with a dry “fine” sand.

CLEAN UP
Water may be used to clean TA-300 S/M from tools and equipment prior to drying. If dried, use a suitable solvent.

PACKAGING
53 gallon drum, 5 gallon pail.

PRECAUTIONS
TA-300 S/M shall not be applied during or when rain is imminent. Application temperature shall be 50°F and rising. Keep away from children. Protect from freezing.